Use this ProPortioner with High Flow AODA or Gas Powered Pumps.
Never ‘batch mix’ your cleaning agents ever again. The patent-pending Pro-Portioner system allows you to draw from individual tanks of your pure products and proportion them to your individual desired mix. Need a 6% mix on the roof and 1% on the house? That’s no problem, simply set your mix ratio and, when you need to change it, turn the valve. Never again will your mix be too strong or too weak, the Pro-Portioner will allow you to adjust your mix on the fly. The Pro Portioner works on the inlet side of your pump system and is compatible with 12volt pumps, air diaphragm pumps, booster pumps, and other demand pump systems.
The Pro-Portioner systems are built for the long haul. You will never need to buy another unit because of a valve malfunction as the system was designed to be fully rebuildable/replaceable if necessary. The water and soap valves have an extremely long lifespan while we recommend the SH (bleach) valve be rebuilt annually for uninterrupted use. Flushing the SH valve is recommended after every use and can be done with ease with the installation of a 3-way valve on the SH intake. Having one side going to SH and the other to water you simply turn the 3 way to water after using and flush system, pump, etc.
How to Operate
For the system to operate you will need: a water tank, bleach tank, and a soap source, pulling soap out of 1-gallon jugs—or 5-gallon pails will work but larger tanks will allow for less refilling and extended run time. Water and bleach tanks will be plumbed from the top with equal length 1/2" lines. The soap supply can use 1/2", 3/8" or even 1/4" as it is just a drip in the system. All pickups must be filtered to control debris intake. The system will vary slightly from user to user, so individual testing may be required. The dial that is on valves goes by degrees 0-180. Look at the specs tab for more information on operating.
Big Shot Supplies Ltd. offers a full one year warranty, in-house only. You may ship it back for a annual inspection within the first year. For the 1st full year, warranty labor will only cost you $50, then, only pay the cost of required non-warrantied parts. Each component that makes up the final assembly has its own individual warranty. The case has a lifetime warranty against manufacturer defects. The wearable items such as valves, check valves, fittings and hinges carry a 90-day warranty against manufacturer defects but do not include damage due to wear or chemical damage.